Author: Noyafa–Cable Tester Manufacturer
What are the main items of wire connector maintenance? 1: How to waterproof the wire connector How to connect the wire connector There are many ways to connect the wire connector, although they seem to be indistinguishable to the layman, but in fact, according to the purpose and the specific application scenario, what are the main items for the maintenance of the wire connector? 1: How to waterproof wire joints? There are many ways to connect wire joints. Although they seem to be indistinguishable to laymen, in fact, according to the differences in use and specific application scenarios, as well as consumers’ own later stages From the perspective of operating habits, the choice of wire joint connection is relatively important. So what are the connection methods of the wire joints? How are the wire joints waterproof? How are the wire joints waterproof? High-voltage waterproof tape, the same as ordinary plastic insulating tape, can be wrapped. This kind of tape looks like rubber, like the black, soft, and thicker color of a car tire. After wrapping it, pinch it into a whole. It is completely sealed and is not afraid of water.
You can buy it anywhere that sells electrical materials. The connection method of the wire connector The power wire connector is divided into“ten”word connection,“-”word connection,“Ding”Spelling, etc. The joint should be tightly wound, smooth and free of thorns.
Before disconnecting the wire head, you should use wire cutters 2: How to solder the wire connector 1. Strip the wire, remove the oxide on the wire (can not be cleaned with an acid solution), and coat the wire end with a soldering iron with a rosin-coated wire ; (This method is mainly used for single-strand wires and wires with small wire diameters) ordinary solder can also be used, and rosin or rosin solution (dissolving rosin in alcohol) before adding solder; 2. Use a soldering pot (iron small pot) , fill it with solder, you can use an electric furnace or other methods to heat and melt the solder), peel the wire, remove the oxide on the wire (can not be cleaned with an acid solution), heat the wire and dip some rosin (or rosin solution), put Put it into the solder pot and dip it evenly; Note: Solder paste or acid solution cannot be used.
Copyright © 2022 SHENZHEN NOYAFA ELECTRONIC CO.,LIMITED - www.noyafa.net All Rights Reserved.