Author: Noyafa–CCTV Tester
Question: The use and maintenance of the cable piercer Answer: The barrel part of the nailer needs to be wiped and maintained after each piercing, so as to prevent the movement of the piston rod from being affected by the collection of carbon and dust. 2. Loosen the barrel and the gun hall during maintenance, and then separate the front barrel and the rear gun. Question: Use and maintenance of the cable piercer Answer: The barrel part of the nailer requires that it be wiped after each piercing maintenance, so as not to affect the movement of the piston rod by collecting carbon and ash. 2. Loosen the barrel and the gun hall during maintenance, then separate the front barrel and the rear barrel, clean it with a special brush, reset the piston rod to the rear barrel after cleaning, and connect the rear barrel Well, exit the cartridge case, connect the barrel and the gun hall into one and save it (Note: If you find that the piston rod is short of oil, you can use cotton yarn to apply a little lubricating oil).
Copyright © 2022 SHENZHEN NOYAFA ELECTRONIC CO.,LIMITED - www.noyafa.net All Rights Reserved.