NOYAFA Electronic specializing in testing instruments and cable testers for 16 years
Language
NOYAFA Electronic specializing in testing instruments and cable testers for 16 years
With the development of technology, there is now more and more cable fault testing equipment on the market, and the smart cable fault tester also appears in people's field of view, which is displayed from the initial oscilloscope, the image tube to the single-chip control, large Screen LCD monitor, etc. With the development of technology, there is now more and more cable fault testing equipment on the market, and the smart cable fault tester also appears in people's field of view, which is displayed from the initial oscilloscope, the image tube to the single-chip control, large Screen LCD monitor, etc. It can be described in a wide variety of dazzling, which is inconvenient to the user's choice.
What kind of cable fault tester is more suitable for China's majority of power users. The following small series gives you some market fault detection equipment. The notebook cable fault tester is a typical application in the computer field, which is undoubtedly technical in technology. The large-capacity data storage and processing functions of the computer, network data transfer features and convenient information management functions provide a better platform for cable fault testers.
If you use it, there is no doubt half-meter. At present, there are several forms of popular notebook cable fault testers in the market: 1. The flash test uses a notebook data collector, a fixed-point, and a plug-in, which is a pack, or a box, or a box. The form of a form of flash test, completely relying on the laptop to perform data acquisition and operation, the ability to the computer is very dependent, and any problem in the computer will directly affect the use of the tester. 2. The flash is in the form of a notebook data collector and a pathometer signal source.
Derivier is individually packaged. Generally, two boxes. Like the first configuration, this configuration is completely dependent on laptop.
3, the flash has independent operation and display system, with a laptop interface on the flash. Route and fixed-point instrument standalily packaged. This configuration, the notebook acts as a secondary tester.
General users rarely use notebooks for testing, because the microcontroller system test fault is convenient, so this configuration has only increased the complexity and cost of the instrument, and the actual significance is not large. 4, the flash uses a computer motherboard, the display is used in the liquid crystal display, essentially similar to the flash performance controlled by the microcontroller. Due to the use of a computer motherboard, its data storage capacity is greater than the flash using the microcontroller.
In addition, some flash can be equipped with a soft drive, a USB interface, and the like for easy communication with a laptop. However, this flash also has the same disadvantage as the notebook flash, which is relatively complicated. The above is a brief introduction of Xiaobian's common notebook cable fault detector on the market. I hope I can give a certain help to a friend who needs. If you want to continue to learn about this knowledge, you can continue to pay attention to Xiaobian. ! Friends, see the next period! .
Copyright © 2022 SHENZHEN NOYAFA ELECTRONIC CO.,LIMITED - www.noyafa.net All Rights Reserved.